Alpine CDE-181RM Manuel d'utilisateur télécharger pdf (Page 32)

31-EN

IMPORTANT

Installation

CAUTION

When you install this unit in your car, do not remove the

detachable front panel.

If the detachable front panel is removed during installation, you

might press too hard and warp the metal plate that holds it in

place.

The main unit must be mounted within 35 degrees of the

horizontal plane, back to front.

Remove the mounting sleeve from the main unit (refer to

“Removal” on page 31). Slide the mounting sleeve into the

dashboard and fix it with the metal shackles.

* If the installed mounting sleeve is loose in the dashboard, the

pressure plates may be bent slightly to remedy the problem.

When your vehicle has the Bracket, mount the long hex

bolt onto the rear panel of the CDE-182R/CDE-181 Series/

CDE-180 Series/UTE-81R and put the Rubber Cap on the

hex bolt. If your vehicle does not have the Mounting

Support, reinforce the head unit with the metal mounting

strap (not supplied). Connect all the leads of the

CDE-182R/CDE-181 Series/CDE-180 Series/UTE-81R

according to details described in the CONNECTIONS

section.

* For the screw

, provide a proper screw to the chassis installing

location.

Slide the CDE-182R/CDE-181 Series/CDE-180 Series/

UTE-81R into the dashboard until it clicks. This ensures

that the unit is properly locked and will not accidentally

come out from the dashboard. Install the detachable front

panel.

Remove the detachable front panel.

Insert the bracket keys into the unit, along the guides on

either side. The unit can now be removed from the

mounting sleeve.

Please record the serial number of your unit in the space provided

below and keep it as a permanent record. The serial number or the

engraved serial number is located on the bottom of the unit.

SERIAL NUMBER: [ ]

INSTALLATION DATE: [ ]

INSTALLATION TECHNICIAN: [ ]

PLACE OF PURCHASE: [ ]

To prevent external noise from entering the audio system.

• Locate the unit and route the leads at least 10 cm away from the

car harness.

• Keep the battery power leads as far away from other leads as

possible.

• Connect the ground lead securely to a bare metal spot (remove

any paint, dirt or grease if necessary) of the car chassis.

• If you add an optional noise suppressor, connect it as far away

from the unit as possible. Your Alpine dealer carries various

noise suppressors, contact them for further information.

• Your Alpine dealer knows best about noise prevention

measures so consult your dealer for further information.

Less than 35°

Rubber Cap (Included)

Bracket

Hex Bolt

(Included)

Mounting Sleeve

(Included)

Dashboard

Pressure Plates*

This unit

Removal

Metal Mounting Strap

Screw

Bolt Stud

Hex Nut (M5)

This unit

Bracket keys

(Included)

This unit

Online-store car audio and autogoods Winauto

winauto.ua

1 2 ... 27 28 29 30 31 32 33 34 35

Commentaires sur ces manuels

Pas de commentaire

Alpine CDE-181RM Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteur Alpine CDE-181RM