Alpine IVX-C806 Manuel du propriétaire télécharger pdf

■ GUIDE FOR INSTALLATION AND CONNECTIONS

FOR AUTHORIZED ALPINE DEALERS

• Please read this GUIDE FOR INSTALLATION

AND CONNECTIONS FOR AUTHORIZED

ALPINE DEALERS and the OWNER’S MANUAL

thoroughly to familiarize yourself with each control

and function. We at ALPINE hope that your new

NVE-N099P will give you many years of

enjoyment.

In case of problems when installing your unit, please

contact your authorized ALPINE dealer.

Points to Observe for Safe Usage

• For safe operation of this system, please read this

manual carefully. We cannot be responsible for

problems resulting from failure to observe the

instructions in this manual.

• Pictorial displays are used to point out safety tips

to prevent harm to yourself or others and property

damage. Here is what these pictorial displays

mean. Knowing them is important to understand

this manual.

•Meaning of displays

Warning

Caution

DO NOT DISASSEMBLE OR ALTER.

Doing so may result in an accident, fire or electric

shock.

KEEP SMALL OBJECTS SUCH AS BOLTS OR

SCREWS OUT OF THE REACH OF CHILDREN.

Swallowing them may result in serious injury. If swal-

lowed, consult a physician immediately.

USE THE CORRECT AMPERE RATING WHEN

REPLACING FUSES.

Failure to do so may result in fire or electric shock.

USE ONLY IN CARS WITH A 12 VOLT NEGATIVE

GROUND.

(Check with your dealer if you are not sure.) Failure to

do so may result in fire, etc.

This symbol means important

instructions. Failure to heed them

can result in injury or material

property damage.

This symbol means important

instructions. Failure to heed them

can result in serious injury or

death.

PRECAUTIONS

BEFORE WIRING, DISCONNECT THE CABLE FROM

THE NEGATIVE BATTERY TERMINAL.

Failure to do so may result in electric shock or injury

due to electrical shorts.

DO NOT ALLOW CABLES TO BECOME ENTAN-

GLED IN SURROUNDING OBJECTS.

Arrange wiring and cables in compliance with the

manual to prevent obstructions when driving. Cables or

wiring that obstruct or hang up on places such as the

steering wheel, shift lever, brake pedals, etc. can be

extremely hazardous.

DO NOT SPLICE INTO ELECTRICAL CABLES.

Never cut away cable insulation to supply power to

other equipment. Doing so will exceed the current

carrying capacity of the wire and result in fire or electric

shock.

DO NOT INSTALL IN LOCATIONS WHICH MIGHT

HINDER VEHICLE OPERATION, SUCH AS THE

STEERING WHEEL OR SHIFT LEVER.

Doing so may obstruct forward vision or hamper

movement etc. and results in serious accident.

DO NOT DAMAGE PIPE OR WIRING WHEN

DRILLING HOLES.

When drilling holes in the chassis for installation, take

precautions so as not to contact, damage or obstruct

pipes, fuel lines, tanks or electrical wiring. Failure to

take such precautions may result in fire.

DO NOT USE BOLTS OR NUTS IN THE BRAKE OR

STEERING SYSTEMS TO MAKE GROUND

CONNECTIONS.

Bolts or nuts used for the brake or steering systems (or

any other safety-related system), or tanks should

NEVER be used for installations or ground connections.

Using such parts could disable control of the vehicle

and cause fire etc.

DO NOT INSTALL THE MONITOR NEAR THE

PASSENGER SEAT AIR BAG.

If the unit is not installed correctly the air bag may not

function correctly and when triggered the air bag may

cause the monitor to spring upwards causing an

accident and injuries.

MAKE THE CORRECT CONNECTIONS.

Failure to make the proper connections may result in

fire or product damage.

1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - PRECAUTIONS

2 GUIDE FOR INSTALLATION AND CONNECTIONSFOR AUTHORIZED ALPINE DEALERS• Please read this GUIDE FOR INSTALLATIONAND CONNECTIONS FOR AUTHORIZEDALPINE DE

Page 2 - Caution

114. MountingNote:The main unit must be mounted within ±5 degrees of thehorizontal plane, left to right, and 30 degrees of thehorizontal plane, back t

Page 3 - Contents

123 Cut the carpet in "x" shape with a cutter andinsert the floor bases 2 from under side ofthe carpet.4 Mount the unit on the carpet with s

Page 4 - 1. Preparation

136. Installing TMC antenna1 Check accessory parts.Cable clamp× 8JASO/ISOAntennaAdaptor2Attaching the film antenna to the front window• Keep the metal

Page 5 - 2. Connections

3PrecautionsIMPORTANTPlease record the serial number of your unit in thespace provided on the back cover of Owner’sManual and keep it as a permanent r

Page 6 - EX-2EX-1

4PRECAUTIONS 21. Preparation 52. Connections 63-1. NVE-N099P Wiring Diagram With IVA-D300R/IVA-D300RB/TME-M770 (Touch panel-compatible Alpine products

Page 7 - CVA-1004R/CVA-1003R

51 Check accessory parts.× 3× 22 Prepare tools and mounting information.3 Park the vehicle in a safe and level location.4 Apply the brake and remove t

Page 8 - TME-M760/TME-M750/TME-M580

62. Connections1 Disconnect the battery (–) terminal.Note:Some vehicles contain a vehicle control computer etc. inthis case, contents of the computer

Page 9 - TME-M006SP/TME-M005P

7POWERGPSDISP.EX-2EX-1ANT.DISPLAY OUTNAVIGATION INREMOTE IN/ OUTPRE IN/OUTAi-NETFRONTLRSUBW.REARPOWER SUPPLYAUX OUTAUX INVIDEOAUDIO(MONO)RLRADIO ANTEN

Page 10 - 4. Mounting

8POWERGPSDISP.EX-2EX-1ANT.12345678910(5A)(5A)AA165103-2. NVE-N099P Wiring Diagram WithCVA-1004R/CVA-1003R*1Improper connection of thespeed pulse line

Page 11 - 5. Confirmation

9POWERGPSDISP.EX-2EX-1ANT.SUB W.REARFRONTAi-NETLRVIDEOCAMERA IN(MONO)LAUX IN 3RRADIO ANTENNA INREMOTE IN/OUTNAVIGATION INDISPLAY OUTPOWER SUPPLYVIDEOA

Page 12 - 6. Installing TMC antenna

10POWERGPSDISP.EX-2EX-1ANT.12345678910(5A)(5A)AA16510VOLUMEMUTESOURCECVA-1000RSET UPV.SELSYSTEM CONTROLMONITOR / RECEIVER 35Wx4TFT COLOR LCDFUNCR D SE