Alpine IVE-W585BT Manuel du propriétaire télécharger pdf (Page 76)

76-EN

In Case of Difficulty

Basic

No function or display.

• Vehicle’s ignition is off.

- If connected according to the instructions, the unit will not

operate with the vehicle’s ignition off.

• Improper power lead connections.

- Check power lead connections.

•Blown fuse.

- Check the fuse on the battery lead of the unit; replace with the

proper value if necessary.

• Internal micro-computer malfunctioned due to interference

noise, etc.

- Press the RESET switch with a ballpoint pen or other pointed

article.

No sound or unnatural sound.

• Incorrect setting of volume/balance/fader controls.

- Readjust the controls.

• Connections are not properly or securely made.

- Check the connections and firmly connect.

Screen not displayed.

• Brightness/Contrast control is set at the minimum position.

- Adjust the Brightness/Contrast control.

• Temperature in the vehicle is too low.

- Increase the vehicle’s interior temperature to operation

temperature range.

• Connections to the DVD are not securely made.

- Check the connections and firmly connect.

• The Parking Brake Lead is not connected.

• The Parking Brake is not engaged.

- Connect the Parking Brake Lead, then engage the Parking

Brake. (See page 86)

Movement of displayed picture is abnormal.

• Temperature in the vehicle is too high.

- Allow the vehicle’s interior temperature to cool.

Radio

Unable to receive stations.

• No antenna, or open connection in the antenna cable.

- Make sure the antenna is properly connected; replace the

antenna or cable if necessary.

Unable to tune stations in the seek mode.

• You are in a weak signal area.

- Make sure the tuner is in DX mode.

• If the area you are in is a primary signal area, the antenna may

not be grounded and connected properly.

- Check your antenna connections; make sure the antenna is

properly grounded at its mounting location.

• The antenna may not be the proper length.

- Make sure the antenna is fully extended; if broken, replace the

antenna with a new one.

Broadcast is noisy.

• The antenna is not the proper length.

- Extend the antenna fully; replace it if it is broken.

• The antenna is poorly grounded.

Make sure the antenna is grounded properly at its mounting location.

• The station signal is weak and noisy.

- If above solution does not work, tune in another station.

Disc

Disc playback sound is wavering.

• Moisture condensation in the disc Module.

- Allow enough time for the condensation to evaporate (about 1

hour).

Disc insertion not possible.

• A disc is already in this unit.

- Eject the disc and remove it.

• The disc is being improperly inserted.

- Insert the disc correctly. (See page 14)

Unable to fast forward or backward the disc.

• The disc has been damaged.

- Eject the disc and discard it; using a damaged disc in your unit

can cause damage to the mechanism.

Disc playback sound skips due to vibration.

• Improper mounting of the unit.

- Securely re-mount the unit.

• Disc is very dirty.

- Clean the disc.

• Disc has scratches.

- Change the disc.

• The pick-up lens is dirty.

- Do not use a commercially available lens cleaner disc. Consult

your nearest Alpine dealer.

Disc playback sound skips without vibration.

• Dirty or scratched disc.

- Clean the disc; a damaged disc should be replaced.

CD-R/CD-RW/DVD-R/DVD-RW/DVD+R/DVD+RW playback

not possible.

• Close session (finalisation) has not been performed.

- Perform finalisation and attempt playback again.

Error displays.

• Mechanical error.

- Press . After the error indication disappears, insert the disc

again. If the above-mentioned solution does not solve the

problem, consult your nearest Alpine dealer.

MP3/WMA/AAC is not played back.

• Writing error occurred. The CD format is not compatible.

- Make sure the CD has been written in a supported format.

Refer to “About MP3/WMA/AAC” (pages 21 to 22), then

rewrite in the format supported by this device.

Unit does not operate.

• Condensation.

- Wait a while (about 1 hour) for the condensation to dry.

If you encounter a problem, please turn the power off, then on again.

If the unit is still not functioning normally, please review the items in

the following checklist. This guide will help you isolate the problem

if the unit is at fault. Otherwise, make sure the rest of your system is

properly connected, or then consult your authorised Alpine dealer.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 94 95

Commentaires sur ces manuels

Pas de commentaire

Alpine IVE-W585BT Manuel du propriétaire Page 76

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes vidéo pour voitures Alpine IVE-W585BT