Alpine CDE-125BT Manuel du propriétaire télécharger pdf (Page 31)

32-EN

Installation

CAUTION

When you install this unit in your car, do not remove the

detachable front panel.

If the detachable front panel is removed during installation, you

might press too hard and warp the metal plate that holds it in

place.

The main unit must be mounted within 35 degrees of the

horizontal plane, back to front.

Remove the mounting sleeve from the main unit (Refer to

“Removal” on page 32). Slide the mounting sleeve into the

dashboard and fix it with the metal shackles.

* If the installed mounting sleeve is loose in the dashboard, the

pressure plates may be bent slightly to remedy the problem.

When your vehicle has the Bracket, mount the long hex

bolt onto the rear panel of the CDE-126BT/CDE-125BT and

put the Rubber Cap on the hex bolt. If your vehicle does

not have the Mounting Support, reinforce the head unit

with the metal mounting strap (not supplied). Connect all

the leads of the CDE-126BT/CDE-125BT according to

details described in the CONNECTIONS section.

* For the screw

, provide a proper screw to the chassis installing

location.

Slide the CDE-126BT/CDE-125BT into the dashboard.

When the unit is in place, make sure the locking pins are

fully seated in the down position. This can be done by

pressing firmly in on the unit while pushing the locking

pin down with a small screwdriver. This ensures that the

unit is properly locked and will not accidentally come out

from the dashboard. Install the detachable front panel.

Remove the detachable front panel.

Use a small screwdriver (or similar tool) to push the

locking pins to the “up” position (see above drawing). As

each pin is unlocked, gently pull out on the unit to make

sure it does not re-lock before unlocking the second pin.

Pull the unit out, keeping it unlocked as you do so.

JAPANESE CAR

Mounting the Microphone

For the sake of safety, mount the microphone in the following location.

• In a stable and secure location.

• In a location that does not inhibit safely driving the vehicle.

• Mount the microphone in a location where the driver’s voice can

easily be picked up.

Choose a location for the microphone that can easily pick up the drivers

voice. Requiring the driver to move towards the microphone for

audibility causes a distraction that could be dangerous.

Less than 35°

Rubber Cap (Included)

Bracket

Hex Bolt

(Included)

Mounting Sleeve

(Included)

Dashboard

Pressure Plates

This unit

Metal Mounting Strap

Screw

Bolt Stud

Hex Nut (M5)

This unit

Removal

Lock Pin

Front Frame

Screw (M5 × 8)

(Included)

This unit

Mounting Bracket

1 2 ... 26 27 28 29 30 31 32 33 34 35

Commentaires sur ces manuels

Pas de commentaire

Alpine CDE-125BT Manuel du propriétaire Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs de médias en voiture Alpine CDE-125BT